Eingang: 7V-35V
Ausgang: 1,25V-25V (per Poti regelbar)
Strom: Max. 3A (per Poti regelbar)

Eingang: 7V-35V
Ausgang: 1,25V-25V (per Poti regelbar)
Strom: Max. 3A (per Poti regelbar)

It is a LED driver buck converter, voltage range 7-35V to 1.25-30V and constant current 0-3A, suitable for solar panels, wind power generator, battery charging so on

 Feature:

• Module Properties: non-isolated Buck constant current, constant voltage module (CC CV) charging module
• Scope:
• High-power constant current LED driver.
• Battery charger (including ferroelectric), 4V, 6V, 12V, 14V, 24V battery charging, nickel-cadmium nickel-metal hydride batteries (battery) charger, solar panels, wind generators.
• Solar Panel, Wind generator voltage regulator, Car Power Supply.
• Input voltage: 7-35V
• Output voltage: 1.25-30V
• Output Current: Max 3A ( If more than 15W, please install the heat sink, this item do not include heat sink)
• Constant current range :0-3A (adjustable)
• Minimum voltage pressure: 2V
• Output power: natural cooling 15W
• Conversion efficiency: 85% (the higher the output voltage, the higher the efficiency
• Operating Temperature: Industrial (-40°c to +85°c) (if ambient temperature exceeds 40 °c, please lower power use, or to enhance heat dissipation)
• Full load temperature rise: 45°c
• No-load Current: typical 10mA (12V to 4.2V)
• Load Regulation: ± 1%
• Voltage Regulation: ± 0.5%
• Current precision and temperature: Actual Testing, Temperature changes from 20 degrees To 100 degrees, Constant current value change Less than 1% (constant current value 1A)
• Dynamic response speed: 5% 200uS
• Potentiometer adjustment direction:Clockwise (increase),Counterclockwise (decrease)
• Indicator LED: Charging LED Red, Full Charge LED Green
• Output Short-circuit Protection:YES
• Input Reverse Polarity Protection:YES
• Output Prevent Countercurrent: YES

Battery Charging method:

• 1. Make sure the recharge battery float voltage and charge current, input voltage of the module.
• 2. adjust constant voltage regulator, the output voltage about 3V.
• 3. With a multimeter ( to 10A) Measuring output Short-circuit current, Also adjust the constant regulator allows Output current reaches a predetermined charge current value;
• 4. Adjust Constant regulator allows Output voltage reaches the float voltage;
• 5. connected to the battery, try charging.
• (1,2,3,4 step input connect power, output do not connect battery.)

LED constant current driver Usage:

• 1. Make sure LED current and the maximum operating voltage;
• 2. adjust constant voltage regulator, the output voltage about 3V.
• 3. With a multimeter ( to 10A) Measuring output Short-circuit current, Also adjust the constant regulator allows Output current reaches a predetermined LED working current value;
• 4. Adjust Constant regulator allows Output voltage Reach LED maximum working voltage;
• 5. Connected to the LED, test.
• (1,2,3,4 take steps input connect power, output do not connected LED.)

Package Includes:

• 1 x DC-DC Converter